Every Single CalculatorOne place for every calculator

Wall stud calculator

Enter the length of a wall to find how many studs to buy and how much lumber you need for the plates.

Example: You are framing a basement and need a stud count for a 20 foot wall with a door in it before you go to the lumber yard.

Your numbers

Studs are usually 16 inches apart, measured center to center. Each corner and each door or window needs a few more.

ft
in
16 or 24 on center.
Adds 2 studs each.
Adds 2 studs each.
%
Covers bowed and split studs.
  • Studs to buy0
  • Studs at regular spacing0
  • Extra for corners and openings0
  • Plate lumber0

Wall stud calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the stud count is worked out

Divide the wall length by the stud spacing and add one for the end. Then add extras for each corner and each opening, and a little for waste.

Studs = wall length × 12 ÷ spacing, rounded up, + 1

Plate lumber = wall length × 3

A framed wall has one bottom plate and two top plates, which is where the three comes from.

A worked example

A 20 foot wall is 240 inches. At 16 inches apart that is 15 spaces, so 16 studs. Two corners and one door add 6 more for 22. With 10% waste you buy 25. The plates need 60 feet of lumber.

Good to know

  • For a standard 8 foot ceiling, buy precut studs that are 92⅝ inches long. With three plates they give a finished wall just over 8 feet.
  • Openings also need a header across the top, sized for the span and the load above. That lumber is not counted here.
  • Use pressure-treated lumber for any bottom plate that sits on concrete.
  • A common shortcut is one stud per foot of wall. It lands close to this figure for walls with a normal number of openings.

Common questions

16 or 24 inch spacing?

Sixteen is the standard for load-bearing walls. Twenty-four is allowed in some cases, often with 2x6 studs. Check your local code.

Why does an opening add studs when it removes some?

Each side of an opening needs a full-height king stud and a shorter jack stud to carry the header, and short cripple studs fill in above and below. That usually comes out to more lumber than the studs it replaces.

How we know this calculator is right

Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: framers and carpenters, drywall hangers and finishers, insulation installers.