How the quantities are worked out
Divide the patio area by the area of one paver, then add waste for the cuts at the edges. The base and sand are the patio area multiplied by their depth.
Pavers = area × 144 ÷ (paver length × paver width) × (1 + waste)
A worked example
A patio 12 by 10 feet is 120 square feet. A 4 by 8 inch paver covers 32 square inches, so there are 4.5 to a square foot and the patio needs 540. With 10% waste you buy 594. Four inches of gravel base is 1.48 cubic yards, and one inch of sand is 0.37.
Good to know
- The base does the real work. Compact it in layers, and add roughly 10% to the gravel figure because it packs down.
- Slope the patio away from the house by about a quarter inch per foot so water runs off.
- Edge restraints around the outside stop the pavers spreading. Measure them by the perimeter.
- You also need joint sand swept into the gaps once the pavers are down. Polymeric sand bags list their coverage.
Common questions
How do I convert gravel to tons?
Multiply cubic yards by about 1.4. The gravel calculator does this and adds compaction.
What about a round or curved patio?
Find the area with the square footage calculator, then enter it as the length with a width of 1. Use 15% waste, since curves need many cuts.
How we know this calculator is right
Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.