How the count is worked out
Joists = deck length × 12 ÷ spacing, rounded up, + 1
Posts = deck length ÷ post spacing, rounded up, + 1
A worked example
A deck 16 feet along the house and 12 feet deep, with joists every 16 inches, needs 13 joists, each 12 feet long. The ledger and the rim joist are 16 feet each. A doubled beam takes 32 feet of lumber. With posts every 8 feet there are 3, each on its own footing. Thirteen hangers fix the joists to the ledger.
Good to know
- The ledger connection is where decks fail. It needs proper structural fasteners into the house frame and flashing above it, not nails.
- Sizes and spans are set by code and depend on the wood species and the load. Use the deck span tables for your area or have it designed.
- Footings go below the frost line and are sized for the load each post carries.
- Stairs, railings, blocking and the decking itself are extra. See the deck board calculator and the stair calculator.
Common questions
Do I need a permit?
Usually, for a deck attached to a house or more than a small height off the ground. Check with your building department before you buy lumber.
How we know this calculator is right
Before this calculator went on the site, 12 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.