How it is worked out
Drill size = thread diameter − 0.01299 × percent of thread ÷ threads per inch
A worked example
A ¼-20 thread at 75%: 0.25 − 0.01299 × 75 ÷ 20 is 0.201 inches, which is a number 7 drill.
Good to know
- Pick the nearest standard drill. For ⅜-16 the answer is 0.314, so use a 5/16 drill.
- In hard or tough metals, drop to 60 or 65% thread to save taps.
- A quick rule that gives nearly the same answer: diameter minus one pitch.
How we know this calculator is right
Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.