Every Single CalculatorOne place for every calculator

Ohm's law calculator

Enter any two of volts, amps and ohms, and leave the third empty. The calculator fills it in and adds the power.

Example: You measured 16 ohms across a water heater element and want to know what it should draw at 240 volts.

Your numbers

Leave exactly one box empty.

V
A
Ω
  • Amps0
  • Volts0
  • Ohms0
  • Power0

The formulas

Volts = amps × ohms

Amps = volts ÷ ohms

Watts = volts × amps

A worked example

A heating element with 8 ohms of resistance on a 120 volt supply draws 15 amps and gives off 1,800 watts.

Good to know

  • Resistance of a heating element or lamp changes as it warms up, so a cold reading with a meter will not match the running figure exactly.
  • This holds for simple resistive loads on single-phase power. Motors and electronics behave differently.
  • Always switch off and test dead before measuring resistance. A meter set to ohms across a live circuit can be destroyed, and so can you.
  • This calculator does not size wire, breakers or fuses. Use your electrical code for those.

Common questions

What is the difference from the watts calculator?

The watts, amps and volts calculator works from power. This one works from resistance.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians.