Every Single CalculatorOne place for every calculator

Drawer box calculator

Drawer box width and height from the cabinet opening.

Example: You are making drawers for a face-frame cabinet with side-mount slides.

Your numbers

Side-mount ball bearing slides need half an inch each side. Check the sheet that comes with yours.

in
in
in
in
  • Drawer box width0
  • Drawer box height0

How it is worked out

Box width = opening width − 2 × slide clearance

Box height = opening height − clearance

A worked example

A 15 inch opening with ½ inch slides takes a box 14 inches wide. In a 6 inch tall opening, make it 5 inches high.

Good to know

  • Undermount slides use different clearances and need a set box width. Use the maker's chart.
  • A box even a sixteenth too wide binds. Measure the opening at the front and the back.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: finish carpenters, cabinetmakers and woodworkers.