Every Single CalculatorOne place for every calculator

Door rough opening calculator

Enter the size of the door to find the rough opening to frame and the length of the header.

Example: You are framing a wall for a 36 inch prehung door and need the opening and the header length.

Your numbers

The usual rule for a prehung interior door is 2 inches wider and 2½ inches taller than the door itself. Check the instructions for your door, because some differ.

in
A 3-0 door is 36 inches.
in
A 6-8 door is 80 inches.
in
in
  • Rough opening width0
  • Rough opening height0
  • Header length0
  • Trimmer stud length0

How the sizes are worked out

Rough opening width = door width + 2 in

Rough opening height = door height + 2½ in

The extra room takes the door frame, leaves space to shim it plumb, and clears the finished floor.

A worked example

A 36 by 80 inch door needs a rough opening 38 inches wide and 82½ inches tall. The header sits on a trimmer stud at each side, so it is 3 inches longer than the opening, which is 41 inches. Each trimmer is 81 inches, the opening height less the 1½ inch bottom plate.

Good to know

  • Header size, as opposed to length, depends on the load above and the span. It comes from your code or plans.
  • Exterior doors, pocket doors, bifolds and double doors all have their own allowances. Use the maker's rough opening figure and change the two add-on boxes to match.
  • Measure the height from the subfloor and allow for the finished floor that is still to go down.
  • Cut the bottom plate out of the opening after the wall is standing.

Common questions

Does this work for windows?

Windows are usually framed half an inch larger than the unit in each direction, but use the rough opening the manufacturer prints for that window.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: framers and carpenters, finish carpenters, glaziers.