How it is worked out
Inches per hour = 96.25 × gallons per minute ÷ area in square feet
Run time in minutes = inches to apply ÷ inches per hour × 60
The 96.25 converts gallons per minute over a square foot into inches of depth per hour.
A worked example
A zone using 12 gallons a minute over 1,000 square feet applies 1.16 inches an hour. To put down half an inch, run it for 26 minutes. That uses about 312 gallons.
Good to know
- Spray heads apply water much faster than rotors. Never mix the two on one zone, or part of the lawn floods while the rest stays dry.
- If water runs off before the time is up, split the run into two shorter cycles with a soak in between.
- To check the real figure, set out straight-sided cans across the zone, run it for 15 minutes and measure the depth.
- Watering deeply and less often grows deeper roots than a little every day.
Common questions
How do I find the flow of a zone?
Add the gallons per minute of each nozzle from the maker's chart, or read the water meter before and after running the zone for a few minutes.
How we know this calculator is right
Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.