Every Single CalculatorOne place for every calculator

Taper calculator

Taper per foot and angle from two diameters and a length.

Example: You need to turn a taper to match a worn pin and have only its two diameters.

Your numbers

Measure the large and small diameters and the distance between them.

in
in
in
  • Taper per foot0
  • Angle to set, from the centre line0
  • Included angle0

How it is worked out

Taper per foot = (large − small) ÷ length × 12

Half angle = arctan((large − small) ÷ 2 ÷ length)

A worked example

From 1 inch down to ½ inch over 6 inches is a taper of 1 inch per foot. Set the compound to 2.39 degrees.

Good to know

  • The compound slide is set to the half angle, not the included angle.

How we know this calculator is right

Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists.