Every Single CalculatorOne place for every calculator

Rectangular to round duct calculator

Enter the sides of a rectangular duct to find the round duct with the same airflow and friction.

Example: A joist bay will only take an 8 inch deep duct and you need to match a 10 inch round trunk.

Your numbers

This is the standard equivalent diameter used on duct charts. It is not the round duct with the same area.

in
in
  • Equivalent round duct0
  • Rectangular area0
  • Aspect ratio0

How it is worked out

Equivalent diameter = 1.30 × (a × b)^0.625 ÷ (a + b)^0.25

A worked example

A 12 by 8 inch duct is equivalent to a round duct of about 10.7 inches, so a 10 inch round is a little small and a 12 inch has room to spare.

Good to know

  • Keep the aspect ratio under about 4 to 1. Flat, wide ducts are noisy and waste fan power.
  • Round to the next standard size up, not down.
  • Sizing ducts for a system should follow a proper duct design method.

How we know this calculator is right

Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: hvac technicians, sheet metal workers.