Every Single CalculatorOne place for every calculator

Roof truss calculator

Enter the length of the building and the truss spacing to find how many trusses to order.

Example: You are ordering trusses for a 40 foot garage and the supplier asks how many at 24 inches on center.

Your numbers

This counts trusses. The truss design itself comes from the manufacturer, who engineers it for your span, pitch and local snow and wind loads.

ft
Along the ridge.
in
24 inches on center is standard.
  • Trusses0
  • Common trusses0
  • Gable end trusses0
  • Hurricane ties0

Roof truss calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the count is worked out

Trusses = building length × 12 ÷ spacing, rounded up, + 1

A worked example

A building 40 feet long with trusses every 24 inches is 480 inches, which is 20 spaces, so 21 trusses. On a gable roof the two at the ends are gable end trusses and the other 19 are common trusses. Two ties per truss is 42.

Good to know

  • Give the truss supplier the span, pitch, overhang, spacing and your address. They design for the loads where you are.
  • Never cut, notch or drill a truss. Every member is working, and altering one can bring down the roof.
  • Trusses must be braced as they go up, following the bracing sheet that comes with them. Unbraced trusses can topple like dominoes.
  • Hip roofs, valleys and attic trusses need special shapes, so the supplier will give you a layout with the exact count.

Common questions

Trusses or rafters?

Trusses span further, go up faster and usually cost less. Rafters leave the attic open. The rafter length calculator covers stick framing.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: framers and carpenters.