Every Single CalculatorOne place for every calculator

Calculators for framers and carpenters

Laying out walls, floors, roofs and stairs. 25 calculators, with the ones used most at the top.

Used most

  1. 1Wall stud calculatorStuds and plate lumber for framing a wall, with extras for corners and openings.
  2. 2Rafter length calculatorCommon rafter length with overhang, cut angles, the board to buy and the rafter count.
  3. 3Stair calculatorNumber of steps, exact riser height, total run and stringer length for a staircase.
  4. 4Feet and inches calculatorAdd or subtract two measurements in feet, inches and fractions.
  5. 5Diagonal calculatorCorner-to-corner diagonal for squaring up a deck, slab, wall or foundation.

Used often

  1. 6Plywood calculatorSheets of plywood or OSB to cover a floor, wall or roof.
  2. 7Roof pitch calculatorPitch, angle and slope from one measurement, plus roof area and shingle bundles.
  3. 8Floor joist calculatorHow many joists, how much rim board and how many subfloor sheets a floor takes.
  4. 9Roof truss calculatorHow many roof trusses a building needs, and the hurricane ties to fix them.
  5. 10Wall sheathing calculatorSheets of plywood or OSB for exterior walls, and rolls of house wrap.
  6. 11Roof sheathing calculatorHow many sheets of plywood or OSB it takes to deck a roof.
  7. 12Door rough opening calculatorRough opening size and header length for framing a door.

Now and then

  1. 13Board foot calculatorBoard feet and cost for any number of boards.
  2. 14Deck framing calculatorJoists, ledger, rim, beam lumber, posts and hangers for a deck frame.
  3. 15Hip rafter calculatorHip and valley rafter length, the common rafter beside it and the jack rafter difference.
  4. 16Right triangle calculatorLong side, angles and area of a right triangle from its two short sides.
  5. 17Baluster spacing calculatorHow many balusters fit between two posts, and the exact gap between them.
  6. 18Wheelchair ramp calculatorRamp length, number of runs and landings for a given rise at a 1 to 12 slope.
  7. 19Arch radius calculatorRadius and arc length of an arch from its width and height.
  8. 20Decimal to fraction calculatorTurn decimal inches into the nearest tape measure fraction.
  9. 21Gable area calculatorArea of the triangle at the end of a gable roof, for siding, sheathing or paint.
  10. 22Linear feet calculatorTotal linear feet and cost from a number of pieces and their length.
  11. 23Deck railing calculatorPosts, balusters and rail for a run of deck railing.
  12. 24Deck screw calculatorScrews to fasten deck boards, from the deck size and joist spacing.
  13. 25Steel stud calculatorMetal studs and track for a wall.

The order is our judgement of how often each sum comes up on the job. If you would rank them differently, or one is missing, tell us. See every trade.