How the radius is worked out
Radius = (width² ÷ 4 + rise²) ÷ (2 × rise)
A worked example
An arch 36 inches wide that rises 6 inches has a radius of 30 inches. The centre point to swing it from is 24 inches below the line between the two ends. The curve itself is 38⅝ inches long.
How to draw it
- Mark the two ends of the arch and the centre between them.
- Measure straight down from that centre by the figure shown for the centre point.
- Fix a nail there, hook on a tape or a strip of wood with a pencil at the radius, and swing the curve between the two ends.
Common questions
What if the rise is half the width?
Then the arch is a full half circle, and the radius is simply half the width.
Where is the arc length useful?
It is the length of flexible trim, bender board or drywall bead needed to follow the curve.
How we know this calculator is right
Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.