Every Single CalculatorOne place for every calculator

Three-phase power calculator

Enter the line-to-line voltage, the current in each line and the power factor to find the power of a three-phase load.

Example: You clamped 20 amps on each leg of a 480 volt motor and want the kilowatts for the load schedule.

Your numbers

Voltage is measured between two lines, such as 208 or 480. Power factor is on the motor or equipment nameplate. Use 1 for a purely resistive load such as heaters.

V
A
  • Real power0
  • Apparent power0
  • In watts0

How it is worked out

kVA = 1.732 × volts × amps ÷ 1,000

kW = kVA × power factor

The 1.732 is the square root of 3, which comes from the three phases being a third of a cycle apart.

A worked example

A motor drawing 20 amps on a 480 volt three-phase supply at a power factor of 0.9 is 16.6 kVA and 15.0 kilowatts.

Good to know

  • This assumes a balanced load, with the same current in all three lines.
  • kVA is what transformers and generators are rated in. kW is the real work being done and what the meter bills.
  • A motor's output power is less than the kilowatts it draws, because of its efficiency. The nameplate horsepower is output.
  • This calculator does not size conductors, overcurrent protection or transformers. Those come from your electrical code and the equipment data.

Common questions

What about single-phase?

Leave out the 1.732. The watts, amps and volts calculator covers single-phase loads.

How we know this calculator is right

Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians.