How the sheet count is worked out
A 4 by 8 sheet covers 32 square feet. Divide the roof area, plus waste, by the area of one sheet and round up.
Sheets = roof area × (1 + waste) ÷ (sheet length × sheet width)
A worked example
A 1,500 square foot roof with 10% waste needs 1,650 square feet of sheathing. Divided by 32, that is 51.6, so you buy 52 sheets.
Choosing sheathing
- OSB and plywood are both common. Plywood handles getting wet during the build a little better, and OSB usually costs less.
- The thickness you need depends on rafter spacing and snow load. Check the span rating stamped on the sheet and your local code.
- Stagger the end joints from row to row and leave the small expansion gap the manufacturer calls for.
- On rafters spaced 24 inches apart, panel clips between the rafters are often required.
Common questions
How much waste should I allow?
10% suits a plain gable roof. Allow 15% for a hip roof or one with several valleys, since the angled cuts leave offcuts you cannot reuse.
I am only replacing damaged sheets. How do I estimate?
Enter the area of the damaged sections instead of the whole roof. You usually cannot see all the rot until the shingles are off, so buy a few spare sheets.
How we know this calculator is right
Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.