Every Single CalculatorOne place for every calculator

Gutter calculator

Enter the length of gutter you need to find how many sections, downspouts, hangers and fittings to buy.

Example: You are quoting gutters on a house with two 40 foot eaves and need sections, downspouts, hangers and elbows on one list.

Your numbers

Measure along each eave that gets a gutter. A run is one continuous stretch of gutter between two ends.

ft
A simple gable house has 2.
ft
Store-bought sections are usually 10 ft.
ft
One downspout for every 30 to 40 ft.
in
Use 18 where snow and ice are heavy.
ft
From the gutter to the ground.
  • Gutter sections0
  • Seamless lengths0
  • Downspouts0
  • Hangers0
  • End caps0
  • Downspout pipe0
  • Elbows0

Gutter calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

Ridge Rake Eave Overhang Span (width) Run Rise Length
The run is half the span. Rakes are the sloped edges at the gable ends, and eaves are the level edges where gutters go.

How the quantities are worked out

Gutter sections are the total length divided by the section length. Each run gets at least one downspout, and long runs get one for every 30 to 40 feet. Hangers go at a regular spacing, plus one extra at the end of each run.

Downspouts = runs × (run length ÷ longest run per downspout, rounded up)

A worked example

A gable house with two 40 foot eaves has 80 feet of gutter in 2 runs. That is 8 ten-foot sections. Each 40 foot run needs 1 downspout, so 2 in all. Hangers every 24 inches come to 40, plus one more per run, for 42. Each run has 2 end caps, so 4. Two downspouts 10 feet tall need 20 feet of pipe and 3 elbows each, or 6 elbows.

Good to know

  • Gutters should slope toward the downspout by about a quarter inch for every 10 feet so water does not stand in them.
  • You also need a drop outlet for each downspout, joint connectors or sealant where sections meet, and straps to fix the downspouts to the wall.
  • Five inch K-style gutters suit most houses. Large or steep roofs in rainy areas may need six inch gutters and bigger downspouts.
  • Seamless gutters are made on site to the exact length, so you would order by run, not by section.

Common questions

Why three elbows per downspout?

Two at the top carry the pipe from the gutter back to the wall, and one at the bottom turns the water away from the foundation.

Where should downspouts go?

At the corners where possible, and where the water can drain away from the house. Avoid emptying onto walkways or a neighbor's property.

Sectional or seamless

Sectional gutters come in fixed lengths that you join with connectors and sealant. Seamless gutters are formed from a coil on site, one piece for each run, so there are no joints to leak along the length. The installer prices seamless by the foot, so give them the total length and the number of runs.

How we know this calculator is right

Before this calculator went on the site, 19 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: roofers, siding and gutter installers.