Every Single CalculatorOne place for every calculator

Soffit and fascia calculator

Enter the length of your eaves and how deep the overhang is to find the soffit panels, fascia and channel to buy.

Example: You are wrapping the eaves on a house with a 16 inch overhang and need panels, fascia and channel on one order.

Your numbers

Soffit panels are cut into short pieces that run from the wall to the fascia. A 12 foot panel gives nine pieces for a 16 inch overhang.

ft
Every edge that gets soffit.
in
Wall to fascia.
ft
in
ft
Enter 0 if the rakes are not being wrapped.
ft
%
  • Soffit panels0
  • Pieces to cut0
  • Fascia pieces0
  • J or F channel pieces0
  • Soffit area0

Soffit and fascia calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the quantities are worked out

Each piece of soffit is as long as the overhang is deep and as wide as the panel. Count the pieces along the eave, then see how many you can cut from one panel.

Pieces = eave length × 12 ÷ panel width

Pieces per panel = panel length × 12 ÷ overhang depth, rounded down

A worked example

Eighty feet of eave with 12 inch wide panels needs 80 pieces, or 88 with waste. A 12 foot panel cut into 16 inch pieces gives 9, so you buy 10 panels. Fascia along 80 feet of eave and 72 feet of rake, with waste, is 14 twelve-foot pieces. Channel on both sides of the soffit is 15.

Good to know

  • Use vented soffit wherever the attic needs intake air. The attic ventilation calculator shows how much.
  • The soffit sits in a channel at the wall, either J or F, and tucks behind the fascia at the outer edge. Some systems need channel on one side only.
  • Aluminum fascia is bent from coil stock or bought preformed to match the board behind it. Measure the board height before ordering.
  • Hip roofs have soffit all the way round and mitred corners, which waste more. Use 15%.

Common questions

What if my overhang is wider than 24 inches?

Wide soffits need a nailer or strapping down the middle to stop the panels sagging. The count works the same way.

How we know this calculator is right

Before this calculator went on the site, 11 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: roofers, siding and gutter installers.