Every Single CalculatorOne place for every calculator

Countertop calculator

Enter the total length of your countertops to find the square feet you need and what it will cost.

Example: A kitchen has 15 feet of counter and the fabricator prices by the square foot.

Your numbers

Measure along the wall, in inches, and add up every run. A standard kitchen counter is 25½ inches deep.

in
in
in
Enter 0 for none.
$
Optional. Installed price.
  • Total area0
  • Countertop0
  • Backsplash0
  • Cost0

How the area is worked out

Square feet = length in inches × depth in inches ÷ 144

A worked example

Counters that total 180 inches long and 25½ inches deep are 31.9 square feet. A 4 inch backsplash along the same length adds 5 square feet, for 36.9 in all. At $60 a square foot installed, that is about $2,213.

Good to know

  • At an inside corner, measure one run to the wall and the other only to the front of the first, so the corner is not counted twice.
  • Islands and peninsulas are measured by their own length and depth. Run the calculator again for those and add the results.
  • Stone is cut from slabs, so the layout and the position of seams affect how many slabs you pay for. Fabricators measure with a template before they quote a final price.
  • Sink and cooktop cut-outs are usually charged for, not deducted.

Common questions

What else is in a countertop quote?

Edge profile, cut-outs, removal of the old tops, plumbing reconnection and sealing are often separate lines. Ask for them to be itemised.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: cabinetmakers and woodworkers, tile setters.