How the liner size is worked out
Liner length = pond length + 2 × depth + 2 × overlap
Liner width = pond width + 2 × depth + 2 × overlap
A worked example
A pond 10 by 8 feet and 2 feet deep, with a foot of overlap all round, needs a liner 16 by 14 feet. As a simple box it would hold about 1,200 gallons. Sloped sides and planting shelves make the real figure lower, often around two thirds of that.
Good to know
- Use the longest, widest and deepest measurements, even for an irregular pond. The liner is a rectangle and the excess is trimmed.
- Put underlayment or old carpet beneath the liner so stones and roots cannot puncture it.
- Do not trim the edges until the pond is full. The weight of the water pulls the liner in.
- The gallons figure is what sizes the pump and filter. Aim to turn the whole volume over about once an hour for a fish pond.
Common questions
Can I join two liners?
Yes, with seam tape made for that liner, but a single piece is far less likely to leak.
How we know this calculator is right
Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.