Every Single CalculatorOne place for every calculator

Electricity cost calculator

Enter what something draws in watts, how long it runs and what you pay for electricity to find what it costs to run.

Example: You are running two site heaters for a month and need to price temporary power into the job.

Your numbers

Your rate is on your electricity bill, in cents or dollars per kilowatt-hour. Enter it in dollars, so 16 cents is 0.16.

W
From the rating plate.
$
Per kilowatt-hour.
  • Cost for the period0
  • Cost per day0
  • Cost per year0
  • Energy per day0

How the cost is worked out

Cost = watts ÷ 1,000 × hours × rate per kilowatt-hour

A worked example

A 1,500 watt heater running 4 hours a day uses 6 kilowatt-hours. At 16 cents each that is 96 cents a day, $28.80 over 30 days and about $350 over a year.

Good to know

  • Motors, compressors and heaters with thermostats cycle on and off, so they draw their rated power only part of the time. Use the hours they actually run.
  • If the plate shows amps and volts but not watts, multiply them, or use the watts, amps and volts calculator.
  • Many utilities charge different rates by time of day or by how much you use. Your bill shows the tiers.
  • A plug-in energy monitor gives a far better figure for anything with a variable load.

Common questions

How do I price temporary power on a job site?

List each tool or heater with its hours per day, run the calculator for each and add the results. Site heaters are usually the biggest cost by far.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians, hvac technicians, solar installers, homeowners.