Every Single CalculatorOne place for every calculator

Ring roll length calculator

Flat length of bar or plate to roll into a ring of a given inside diameter.

Example: You are rolling a band to fit round a 24 inch tank.

Your numbers

Metal bends about its centre line, so the length is worked on the middle of the thickness.

in
in
  • Flat length to cut0
  • Outside diameter0

How it is worked out

Flat length = 3.1416 × (inside diameter + thickness)

A worked example

A ring 24 inches inside from ¼ inch flat bar needs 3.1416 × 24.25, or 76 3/16 inches.

Good to know

  • Rolls leave a short flat at each end. Cut long and trim, or pre-bend the ends.

How we know this calculator is right

Before this calculator went on the site, 4 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators, sheet metal workers.