How the board count is worked out
Each row takes up the width of a board plus one gap. Divide the deck width by that to get the number of rows, then multiply by the deck length for the total length of decking.
Rows = deck width × 12 ÷ (board width + gap), rounded up
Boards = rows × deck length × (1 + waste) ÷ board length, rounded up
A worked example
A deck 12 feet wide is 144 inches. A 5½ inch board with a ⅛ inch gap takes 5⅝ inches, so the deck needs 26 rows. At 16 feet long that is 416 feet of decking. With 10% waste and 16 foot boards, you buy 29. Joists every 16 inches come to 13, and two screws where each board crosses each joist is 676 screws.
Good to know
- Buy boards as long as the deck if you can. Full-length boards mean no butt joints and less waste.
- Wet pressure-treated boards shrink as they dry, so many builders lay them tight. Composite boards need the gap the maker specifies.
- Laying boards on a diagonal uses about 15% more material and usually needs joists 12 inches apart.
- The joist count covers the joists under the boards. Rim joists, beams, posts and blocking are extra, and their sizes come from span tables in your code.
Common questions
How many screws per board?
Two at every joist. Hidden fastener systems use one clip per joist per board, so halve the screw figure for a clip count.
Should the last board be ripped down?
Often, yes. It is better to adjust the gaps slightly across the deck or trim the last row than to finish with a thin strip.
Wood or composite
- Composite and PVC boards expand with heat, so makers set the gap, often 3/16 inch between boards and more at the ends. Follow their chart.
- Hidden clip systems use one clip where each board crosses each joist, which is half the number of fixings that face screwing takes. The first and last boards are still face screwed or fixed with starter clips.
- Many composite boards need joists 16 inches apart at most, and 12 inches for diagonal layouts or stairs.
How we know this calculator is right
Before this calculator went on the site, 20 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.