How the nail count is worked out
Multiply the squares of roofing by the shingles in a square and the nails in each shingle.
Nails = squares × (1 + waste) × shingles per square × nails per shingle
A worked example
A 1,500 square foot roof with 10% waste is 16.5 squares. At 80 shingles a square and 4 nails each, that is 320 nails per square and 5,280 nails in all. Coil nails come 120 to a coil, so you need 44 coils, which is less than one 60-coil box. At 6 nails per shingle the same roof takes 7,920 nails, or 66 coils.
Good to know
- Starter strips, ridge caps and flashing all take extra nails. One box usually leaves enough spare on a roof this size.
- Nails must go through the shingles and the full thickness of the decking, or at least three quarters of an inch into thicker boards. Inch and a quarter nails suit most single-layer jobs.
- Place nails on the nailing line marked on the shingle. High or crooked nails are a common reason for blow-offs.
Common questions
When do I need 6 nails per shingle?
Shingle makers call for 6 in high wind zones and on very steep slopes, and some local codes require it everywhere. The wrapper shows the pattern.
Can I use staples?
Most shingle makers and codes now require nails. Staples hold less well and can void the warranty.
How we know this calculator is right
Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.