How the amount is worked out
Add up the four walls, take out the doors and windows, multiply by the number of coats and divide by what a gallon covers.
Wall area = 2 × (length + width) × height − doors − windows
Gallons = area × coats ÷ coverage per gallon
A worked example
A 12 by 12 foot room with 8 foot walls has 384 square feet of wall. One door and two windows take out 51, leaving 333. Two coats is 666 square feet of painting, which at 350 per gallon is 1.9 gallons, so you buy 2. Add the 144 square foot ceiling and it becomes 2.7 gallons, so you buy 3.
Good to know
- Bare drywall, fresh plaster and big colour changes need primer first. Primer is a separate product and usually covers less per gallon than paint.
- Textured walls and rough surfaces can use 20% more paint or more.
- Ceilings usually get their own flat ceiling paint, so buy that separately from the wall colour.
- Trim and doors take little paint. A quart often does the trim in an average room.
- Buy all the paint for a room in one go, or mix the cans together, so the colour matches.
Common questions
Do I really need two coats?
Usually. One coat rarely hides the old colour evenly, and the second coat gives the finish its durability.
How much extra should I buy?
The calculator rounds up to whole gallons, which normally leaves enough for touch-ups. If the exact figure is very close to a whole number, consider an extra quart.
How we know this calculator is right
Before this calculator went on the site, 12 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.