Every Single CalculatorOne place for every calculator

Three-point saddle bend calculator

Enter the height of the obstacle and the distance to its centre to find where to mark the conduit.

Example: A run of half inch EMT has to hop over a 2 inch water pipe 30 inches from the last coupling.

Your numbers

This is the standard saddle with a 45 degree centre bend and two 22½ degree outer bends.

in
in
  • Center mark0
  • First outer mark0
  • Second outer mark0
  • Shrink0

How it is worked out

Shrink = 3/16 inch for each inch of obstacle height

Center mark = distance to the obstacle + shrink

Outer marks = center mark ± 2.5 × obstacle height

A worked example

To cross a 2 inch pipe 30 inches away, mark the centre at 30⅜ inches and the outer bends 5 inches either side, at 25⅜ and 35⅜.

Good to know

  • Bend the centre 45 degrees on the rim notch or teardrop mark of the bender, then the two outer bends at 22½ on the arrow.
  • Keep all three bends in one plane or the saddle will twist.
  • The conduit offset calculator covers plain offsets.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians.