Every Single CalculatorOne place for every calculator

Joint compound calculator

Enter the area of drywall you are finishing to find how much joint compound and tape to buy.

Example: You are finishing a basement with 2,000 square feet of board and need buckets of mud and rolls of tape.

Your numbers

The starting figures are common estimating rates for three coats of ready-mixed compound. Your product and finish level may differ, so check the bucket.

sq ft
From the drywall calculator.
gal
gal
ft
ft
ft
Total length that needs corner bead.
ft
  • Buckets of compound0
  • Compound needed0
  • Tape needed0
  • Rolls of tape0
  • Corner bead pieces0

Joint compound calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the amounts are worked out

Compound = drywall area ÷ 1,000 × gallons per 1,000 sq ft

Tape = drywall area ÷ 1,000 × feet per 1,000 sq ft

A worked example

One thousand square feet of drywall at 9.4 gallons per thousand needs 9.4 gallons of compound, which is 3 buckets of 4.5 gallons. Tape at 370 feet per thousand is 370 feet, so 2 rolls of 250 feet.

Good to know

  • A smooth, paint-ready finish over the whole surface uses more compound than the starting rate. A garage that only gets taped uses less.
  • Setting-type powder is mixed with water and sold by weight, so its coverage is listed differently. Check the bag.
  • Longer sheets and careful layout mean fewer joints, less tape and less mud.
  • Every outside corner needs bead, and so do the edges of openings that are not trimmed with casing.

Common questions

All-purpose or lightweight compound?

All-purpose bonds tape well and suits the first coat. Lightweight and topping compounds sand more easily and suit the finish coats. Many finishers use both.

How we know this calculator is right

Before this calculator went on the site, 12 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: drywall hangers and finishers.