How the panel count is worked out
Metal panels are laid side by side along the eave, each one covering a fixed width. Divide the eave length by that width and round up, then multiply by the number of roof sides.
Panels per side = eave length × 12 ÷ coverage width
Panel length = eave to ridge, rounded up to the next inch
A worked example
A roof side 42 feet long is 504 inches. At 36 inches of coverage that is 14 panels a side, or 28 for a gable roof. With 17.9 feet from eave to ridge, order panels 17 feet 11 inches long. The two sides total 1,504 square feet, which at 80 screws a square is about 1,200 screws. The ridge needs 42 feet of cap.
Good to know
- Suppliers cut panels to the length you order, so measure the rafter length carefully and include the overhang at the eave.
- The last panel on each side is usually cut lengthwise to fit. The offcut can sometimes start the other side.
- You also need eave trim, gable trim, closure strips under the ridge cap and sealant tape. Ask your supplier for a trim list.
- Most metal panels have a minimum pitch, often 3/12 for exposed-fastener panels. Check before you order.
Common questions
Does this work for standing seam?
Yes for the panel count. Enter the coverage width of your panel, commonly 12 to 18 inches. Standing seam uses hidden clips, not exposed screws, so ignore the screw figure.
How many screws per panel?
It depends on the purlin or screw-line spacing. Eighty per square is a planning figure. The manufacturer's fastening chart gives the real pattern.
Panel types
- Ribbed and R-panels usually cover 36 inches and are fixed with screws through the face of the panel.
- Classic corrugated sheets are about 26 inches wide and cover 24 inches once lapped.
- Standing seam panels are narrower, commonly 12 to 18 inches, and are held by hidden clips along each seam. The clip spacing comes from the manufacturer, so the calculator does not count screws for this type.
How we know this calculator is right
Before this calculator went on the site, 15 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.