How the amount is worked out
Multiply the total wall length by the wall height, add the triangles at the gable ends, take out the doors and windows, and add waste. Divide by 100 for squares.
Gable area = width × height ÷ 2
Squares = (walls + gables − openings) × (1 + waste) ÷ 100
A worked example
A 40 by 30 foot house has 140 feet of wall. At 9 feet tall that is 1,260 square feet. Two gable ends 30 feet wide and 7.5 feet tall add 225. Two doors and ten windows take out 192, leaving 1,293 square feet. With 10% waste you need 1,422 square feet, so you order 15 squares.
Good to know
- Vinyl siding usually comes two squares to a box. Fibre cement and wood lap siding are sold by the board, so ask the supplier to convert squares to pieces for your exposure.
- Gable ends waste more than plain walls because every course is cut at an angle. Use 15% if the house has several.
- Siding also needs starter strip, J-channel around every opening, corner posts and house wrap. Measure those by the linear foot.
- Some installers do not subtract small windows, since the offcuts are rarely reusable. Set windows to 0 to estimate that way.
Common questions
How do I find my gable height?
Multiply half the gable width by the roof pitch over 12. A 30 foot wide gable under a 6/12 roof is 15 × 6 ÷ 12, which is 7.5 feet. The roof pitch calculator can find the pitch.
Does this work for a two-storey house?
Yes. Enter the full wall height from the foundation to the eave.
How each siding type is counted
- Vinyl is sold by the square, usually two squares to a box.
- Lap siding, whether fibre cement or wood, is sold by the plank. What matters is the exposure, the part of each plank left showing after the next one laps over it. A 12 foot plank with 7 inches of exposure covers 7 square feet.
- Panel siding comes in 4 by 8 foot sheets that cover 32 square feet each. Taller sheets are made for walls over 8 feet.
How we know this calculator is right
Before this calculator went on the site, 20 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.