Every Single CalculatorOne place for every calculator

Drill point length calculator

Length of the point on a twist drill, to drill to a full-diameter depth.

Example: A print calls for a hole 0.750 deep at full diameter.

Your numbers

Add the point length to the depth you need at full diameter.

in
  • Point length0

How it is worked out

Point length = (diameter ÷ 2) ÷ tan(point angle ÷ 2)

A worked example

A ½ inch drill with a 118 degree point has a point 0.150 inches long, which is the old rule of 0.3 times the diameter.

Good to know

  • For a blind hole that must be 1 inch deep at full size, drill 1 inch plus the point length.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists.