How the amount is worked out
Find the volume in cubic inches, then convert. A US gallon is 231 cubic inches, and there are 128 fluid ounces in a gallon.
Fluid ounces = length × width × thickness ÷ 231 × 128
A worked example
A table top 48 by 24 inches with an eighth of an inch flood coat is 144 cubic inches. With 10% extra that is 158 cubic inches, or about 88 fluid ounces. At a 1 to 1 ratio that is 44 ounces of resin and 44 of hardener.
Good to know
- Measure by volume or by weight exactly as the product says. Resin and hardener have different densities, so a ratio by volume is not the same ratio by weight.
- Bare wood soaks up epoxy. Brush on a thin seal coat first and let it set, or the flood coat will be short and full of bubbles.
- Every product has a maximum depth per pour. Table-top epoxies are usually limited to about a quarter inch. Thicker pours need a deep-pour resin, or the heat of the reaction can crack it.
- Work in a warm room. Cold epoxy is thick, traps bubbles and may not cure.
Common questions
How do I work out a river table?
Enter the length of the river, its average width and the thickness of the slab. Rivers are irregular, so add 15 to 20% in place of 10.
How we know this calculator is right
Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.