How the setting is worked out
Two pieces meeting at a corner each take half the angle. A miter saw measures from a square cut, so the setting is 90 minus half the corner angle.
Saw setting = 90 − corner angle ÷ 2
Corner angle of a frame = (sides − 2) × 180 ÷ sides
A worked example
A square corner of 90 degrees needs both pieces cut at 45. A bay window corner of 135 degrees needs 22.5. A six-sided planter has 120 degree corners, so each end is cut at 30.
Good to know
- A corner that measures 88 degrees needs 46 on the saw, not 45. That one degree is the gap you see in a badly fitting joint.
- Cut test pieces from scrap before you cut your trim.
- This is for flat stock such as baseboard, casing and frames. Crown molding leans out from the wall and needs the crown molding angle calculator.
Common questions
What is an eight-sided frame cut at?
22.5 degrees. Each corner of a regular octagon is 135 degrees.
How we know this calculator is right
Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.