Every Single CalculatorOne place for every calculator

LED resistor calculator

Resistor to run an LED from a supply voltage.

Example: You are wiring an indicator light on a project.

Your numbers

V
V
mA
  • Resistor0
  • Power in the resistor0

How it is worked out

Resistor = (supply − LED voltage) ÷ current

A worked example

From 5 volts to a 2 volt LED at 20 mA: 3 ÷ 0.02 is 150 ohms.

Good to know

  • Pick the next standard value up. This is for low-voltage hobby circuits.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: tech and screens.