Every Single CalculatorOne place for every calculator

Drip edge and ridge cap calculator

Enter the lengths of your roof edges to find how many pieces of drip edge and bundles of ridge cap to buy.

Example: The shingles are ordered and you remember the trim. Enter the eave, rake and ridge lengths to get drip edge pieces and cap bundles on the same delivery.

Your numbers

Eaves are the level bottom edges. Rakes are the sloped edges at the gable ends. Coverage for cap shingles is printed on the bundle.

ft
ft
On a gable roof, four times the rafter length.
ft
Usually sold in 10 ft pieces.
ft
ft
Enter 0 for a gable roof.
ft
Often 20 to 35 linear feet.
%
  • Drip edge pieces0
  • Edge to cover0
  • Ridge cap bundles0
  • Ridge and hip length0

Drip edge and ridge cap calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

Ridge Rake Eave Overhang Span (width) Run Rise Length
The run is half the span. Rakes are the sloped edges at the gable ends, and eaves are the level edges where gutters go.

How the quantities are worked out

Drip edge runs along every outside edge of the roof. Add the eaves and rakes, allow for the overlap where pieces meet, and divide by the piece length.

Drip edge pieces = (eaves + rakes) × (1 + waste) ÷ piece length

Cap bundles = (ridge + hips) × (1 + waste) ÷ coverage per bundle

A worked example

A 40 by 30 foot gable house with a 1 foot overhang has two eaves of about 40 feet and four rakes of about 18 feet, so 80 feet of eave and 72 feet of rake. That is 152 feet, or 167 feet with 10% for laps, which takes 17 ten-foot pieces. The 40 foot ridge needs 44 feet of cap with waste, which is 2 bundles at 33 feet each.

Good to know

  • Pieces of drip edge should overlap by a couple of inches at each joint, which is what the waste allowance covers.
  • At the eaves, drip edge goes under the underlayment. On the rakes it goes over it.
  • Hip and ridge shingles come in different coverage lengths by brand. Thicker high-profile caps cover less per bundle.

Common questions

How do I find my rake length?

Each rake is one rafter long, measured from the ridge to the eave edge. The rafter length calculator gives you that figure. A gable roof has four rakes.

Can I cut three-tab shingles into ridge caps?

Yes. Each three-tab shingle cuts into three caps. Architectural shingles are too thick to bend cleanly, so they use purpose-made cap shingles.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: roofers.