Every Single CalculatorOne place for every calculator

Length conversion calculator

Type a length in any common unit and see it in all the others at once, including feet and inches to the nearest sixteenth.

Example: The cabinet drawings are in millimeters and your tape is in inches. Convert 2,440 mm before you cut.

Your numbers

Useful when plans are in metric and your tape is not, or the other way round.

  • Feet and inches0
  • Inches0
  • Feet0
  • Yards0
  • Millimeters0
  • Centimeters0
  • Meters0

The conversions

Everything is based on one exact figure: an inch is 25.4 millimeters.

1 foot = 12 inches = 304.8 mm

1 yard = 3 feet = 0.9144 m

1 meter = 39.37 inches = 3.281 feet

A worked example

A 10 foot board is 120 inches, 3.333 yards, 3,048 millimeters or 3.048 meters. Going the other way, a 2,440 millimeter sheet is 96.06 inches, which is why a metric sheet is very close to an 8 foot one but not identical.

Handy figures to remember

  • 25 mm is just under an inch. 100 mm is just under 4 inches.
  • A meter is about 3 feet 3⅜ inches.
  • An eighth of an inch is about 3 mm, and a sixteenth is about 1.5 mm.

Common questions

How do I convert square or cubic measurements?

Those use different factors. A square meter is 10.764 square feet and a cubic yard is 27 cubic feet. The square footage calculator shows area in both systems.

Why does the feet and inches answer look slightly different?

It is rounded to the nearest sixteenth of an inch so you can find it on a tape. The decimal figures beside it are not rounded that way.

How we know this calculator is right

Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists, mechanics, unit conversions.