How the amount is worked out
Add up the walls, take out the doorways, add waste for the mitre cuts, and divide by the length of the pieces you are buying.
Trim = (2 × (length + width) − doorways) × (1 + waste)
A worked example
A 12 by 12 foot room has 48 feet of wall. One doorway takes out 3 feet, leaving 45. With 10% waste you need 49.5 feet, which is 5 pieces of 12 feet.
Good to know
- Buy pieces long enough to span each wall in one length where you can. A joint in the middle of a wall always shows a little.
- List each wall and match it to a piece before you buy. Total footage alone can leave you with offcuts that are all too short.
- Crown molding wastes more than baseboard, because the compound cuts at the corners are easy to get wrong. Allow 15%.
- Door and window casing is measured per opening. A standard door takes about 17 feet for one side.
Common questions
Should inside corners be mitred or coped?
Coped joints stay tight as the wood moves and are the usual choice for baseboard and crown. Outside corners are mitred.
How much quarter round or shoe molding do I need?
The same length as the baseboard. Run the calculator once and use the figure for both.
How we know this calculator is right
Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.