How it is worked out
Gallons per minute = container size ÷ seconds × 60
A worked example
A 5 gallon bucket that fills in 30 seconds means 10 gallons per minute.
Where this turns up
- Sizing an irrigation system. Every zone has to use less water than the supply can deliver.
- Checking a well pump or a pressure problem. A flow that has dropped since last year points to the pump, the screen or a blockage.
- Choosing a tankless water heater, which is rated by the flow it can heat.
- Working out how long a pool, pond or tank takes to fill.
Common questions
Is this the same at every tap?
No. Flow depends on the pipe size and length to that tap and on any restrictor fitted to it. Test at the outside tap nearest the meter for the best figure for the supply.
How we know this calculator is right
Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.