Every Single CalculatorOne place for every calculator

Calculators for sheet metal workers

Flat patterns and duct sizes. 11 calculators, with the ones used most at the top.

Used most

  1. 1Bend allowance calculatorBend allowance and bend deduction for sheet metal, to find the flat length.
  2. 2Rectangular to round duct calculatorRound duct that carries the same air as a rectangular duct.
  3. 3Duct velocity calculatorAir speed in a round or rectangular duct from the airflow and duct size.
  4. 4Steel weight calculatorWeight of steel, stainless or aluminum plate, flat bar and round bar.
  5. 5Circle calculatorCircumference and area of a circle from its diameter.

Used often

  1. 6Cone layout calculatorFlat pattern for a cone or a tapered transition, from its diameters and height.
  2. 7Sheet metal gauge calculatorThickness and weight of steel sheet from its gauge number.
  3. 8Right triangle calculatorLong side, angles and area of a right triangle from its two short sides.
  4. 9CFM calculatorAirflow in cubic feet per minute to change the air in a room a set number of times an hour.
  5. 10Decimal to fraction calculatorTurn decimal inches into the nearest tape measure fraction.
  6. 11Ring roll length calculatorFlat length of bar or plate to roll into a ring of a given inside diameter.

The order is our judgement of how often each sum comes up on the job. If you would rank them differently, or one is missing, tell us. See every trade.